Freemotion 730 - Page 10

10
5. Identify the Left and Right Base Covers (88, 89).
Slide the Left Base Cover onto the Left Upright
(84). Slide the Right Base Cover onto the Right
Upright (85). Do not press the Base Covers
into place yet.
84
88
85
89
5
4. Hold the Left Upright (84) against the Base (29).
Be careful not to pinch the wires. If neces-
sary, position the base ground wire (A) in the
hole in the side of the Left Upright. Insert two
3/8"x23/4"Screws(22)andtwo3/8"x11/4"
Screws(3)withtwo3/8"StarWashers(10)into
the Left Upright.
 Partiallytightenthe3/8"x23/4"Screws(22)
andthe3/8"x11/4"Screws(3)untiltheheads
of the Screws touch the Left Upright (84); do
not fully tighten the Screws yet. Note: It may
behelpfultousetheshortHexKey(63)onthe
Screw shown.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the right
side.
84
29
4
3
22
10
A
10
63