12
ENGLISH
1
2
Performing a Control Solution Test
Insert the top of the test strip into your meter
until it stops. This will power on the meter.
System Check Screen
Each time the meter powers on, this screen
briey appears so that you can make sure the
display is working properly.
The date and time will briefly appear after the
system check screen so that you can make sure
your meter is set to the correct time and date.
Wait for the meter to display the blood drop and
test strip symbols.
Gently touch only one of the sample areas on
the test strip to the control solution.
Important: Do not apply control solution to both
test strip sample areas.
If the sound is on, your meter will beep when the test strip is full. A
short line then moves clockwise around the display screen while the
sample is processing.
System Check
3
To Next Page
Loading...
