FreeWave Technologies Spread Spectrum Transceiver User Manual
900 MHz and 2.4 GHz
V5.0S
18
Note: The Subnet ID works only in Multipoint Networks using NetworkID.
Note: In typical Multipoint Networks the Freq Key must be at the same setting for
all transceivers. If the SubnetID is used the sub network may be set to a
different Freq Key.
Note: If both Rcv SubnetID and Xmit SubnetID are set to 0 the SubnetID will show
Roaming in the menu. This setting will allow a mobile slave to roam from
subnet to subnet within a network.
To Next Page
Loading...
