P a g e | 15 of 40
FREMCO A/S
ELLEHAMMERVEJ 14 | DK9900 FREDERIKSHAVN, DENMARK | VAT NO.: DK30815416
TELEPHONE +45 7230 1213 | SALES@FREMCO.DK | WWW.FREMCO.DK
10.3. USE OF “TOUCH” CONTROL UNIT
The control unit is used for operating the fiber blowing machine as well as adjusting the different parameters, for
instance speed and torque level.
10.3.1. Adjustable Parameters
To avoid overload of the fiber cable, it is possible to adjust the maximum torque
level. If this maximum torque level is exceeded during blowing, the protection
technology stops the machine so that the fiber cable does not get damaged. The
torque level can be adjusted from 10 to 100% of the motor’s maximum effect.
Here you can choose a distance that the cable should be blown. When the pre-set
distance has been reached, the machine will stop automatically. If the counter is
set at “0”, the machine will continue indefinitely.
Here the speed of the machine can be adjusted in meter per minute.
Adjusts the acceleration when the machine starts. It can be adjusted between 5
and 100, with 100 being the fastest acceleration. Recommend value: 5
Adjusts the deceleration when the machine stops. It can be adjusted between 5
and 100, with 100 being the fastest deceleration. Recommend value: 100
TOUCH Display
Used to monitor and
adjust various parameters
ON/OFF Switch
Starts and stops the
machine
To Next Page
Loading...
