P a g e | 7 of 40
FREMCO A/S
ELLEHAMMERVEJ 14 | DK9900 FREDERIKSHAVN, DENMARK | VAT NO.: DK30815416
TELEPHONE +45 7230 1213 | SALES@FREMCO.DK | WWW.FREMCO.DK
4. SAFETY
INSTRUCTIONS
• Read and understand this operating manual
before operating the MicroFlow. Follow all
safety instructions. Failure to follow the
instructions may lead to damage on the
machine and mild to severe personal injury.
• All operators must have relevant technical
training, or have undergone thorough training
by an experienced operator.
• Always use protective eye wear.
• Always wear safety shoes.
• Never wear loose clothing.
• Make sure to disconnect the machine from the
air compressor and the power supply, before
any kind of adjustment and maintenance takes
place.
• The air pressure should never exceed the
recommendations from the suppliers of
microducts and fiber. The pressure may never
exceed machine maximum pressure: 16 bar,
which is the maximum pressure for the
MicroFlow blowing machine.
WARNING: Exceeding max
pressure may lead to machine damage
and mild to severe personal injury.
• Open lid: Do not operate the machine with an
open lid due to risk of getting in contact with
moving parts.
WARNING: Operation with an
open lid may lead to personal injury.
• Protective covers: Do not remove the
protective covers of the machine for daily use.
Protectives covers must only be removed by
authorized personnel for service and
maintenance, and only if power and
compressed air supply is disconnected.
After all kind of service and maintenance,
protective covers must be put back in place
and secured properly with all screws before
operating.
WARNING: Operation without
protective covers may lead to
machine damage and personal injury.
• Pressurised components must be undamaged
and intended for use within the machine’s
pressure and temperature range. Daily visual
inspection is necessary to avoid failure.
WARNING: Use of damaged
pressurised components (e.g. hoses,
pipes, ducts, connectors) may lead to machine
damage and mild to severe personal injury.
Daily visual inspection is necessary to avoid
failure.
• Electronic components must be undamaged.
Daily visual inspection is necessary to avoid
damaged electronic components.
WARNING: Use of damaged
electronic components (wiring,
enclosures) may lead to personal injury.
• Exhaust of dust and particles:
The operator must ensure that neither
operator nor spectators are exposed to the
danger of exhaust of dust and particles, and
the operator must ensure that the duct is
fastened correctly.
WARNING: Exhaust air can
contain objects, dust and particles
that may be ejected from duct and machine
during the blowing process. This may lead to
eye or other personal injury. Always use
protective eye wear.
• Ejection of pressurised components: The
operator must ensure that duct and other
pressurised components and utilities are
fastened correctly.
To Next Page
Loading...