P a g e | 23 of 40
FREMCO A/S
ELLEHAMMERVEJ 14 | DK9900 FREDERIKSHAVN, DENMARK | VAT NO.: DK30815416
TELEPHONE +45 7230 1213 | SALES@FREMCO.DK | WWW.FREMCO.DK
• Press the Start/stop button on the physical
controller, and the machine will accelerate to
the pre-set maximum speed
• After 10-20 meters, turn on air. Gradually
increase air supply as the blowing is proceeding.
• The blowing is now running automatically
• If the machine stops unintentionally, there are
two adjustable parameters:
• increase air supply
• or reduce speed if there is no more air
pressure
• Stop the machine, either manually or when
reaching the pre-set distance
• Turn off air
• The lid can be opened when the air pressure
gauge is at “0” bar/psi
WARNING: Do not open the
machine while under pressure, as this
may damage the machine and cause
personal injury.
To Next Page
Loading...
