17
4.7 Display voltage and frequency
Before or after the fusion: To display the voltage and frequency press the
INFO button. The STOP button will take you back to the basic setting.
During fusion: Pressing the INFO button will display the voltage and frequency,
after 3 seconds the unit will automatically go back to the basic setting.
WARNING ! Your FRIAMAT
®
model is designed for an input voltage
range of 200 - 260 volts. If you are working in the range
from 150 - 200 volts or 260 - 320 volts the actual voltage
and frequency will automatically appear on the display.
You can ignore this warning note by pressing the STOP
button and carry on working but there is a risk that
you will damage the electronics of your FRIAMAT
®
model.
If the input voltage range is under 150 volts or above
320 volts the actual voltage and frequency will likewise
appear on the display. In this case, however, the warning
indication will remain until you have regulated the input
voltage back into the recommended range and have
acknowledged with the STOP button.
Voltage: 221.3 V
Frequency: 50.01 Hz
End of fusion
t: 53 s tc: 53 s
FRIA MON 63 mm
Pipe processed ?
FRIA MON 63 mm
START Infotext
To Next Page
Loading...
