8
1.8 Safety precautions on site
IMPORTANT ! All the fusion units of the FRIAMAT
®
Family are splash
proofed. They must not be, however, dipped in water.
1.9 Signal equipment
The fusion units of the FRIAMAT
®
Family confirm certain operating processes
with an acoustic signal tone (1, 2, 5 tones or a continuous tone). These
signals have the following meanings:
Signal tone x 1 means: Confirmation of reading in a bar code
Signal tone x 2 means: Fusion process ended.
Signal tone x 3 means: Supply voltage too low / too high.
Signal tone x 5 means: Warning - Fault. Look at the display !
1.10 Emergencies
In an emergency switch the master switch to “OFF” immediately and
disconnect your FRIAMAT
®
model from the power supply ! The fusion units of
the FRIAMAT
®
Family can be stopped by:
- operating the master switch
- pulling out the power supply plug
To Next Page
Loading...
