Friedrich FSHW091 - Removal Procedures; Indoor Unit Removal

63 PB
REMOVAL
Indoor Unit
a
b
Axile bush
Horizontal louver
Location of step motor
ProcedureStep
2. Remove horizontal louver
Front panel
Front
case
Groove
Push out the axile bush on horizontal
louver. Bend the horizontal louver with
hand and then separate the horizontal
louver from the crankshaft of step motor
to remove it.
the groove on the front panel.
respectively.
that are locking the display board.
(1)A1 display: Screw off the 2 screws that
are locking the display board. Separate
the display board from the front panel.
(2)A3/A5 display: Screw off the 2 screws
3. Remove panel
Separate the panel rotation shaft from
removes the front panel.
Panel
Screws
Screws
Screws
A1 display
A5 display
A3/A6 display
Front panel
Panel rotation
Groove