Friedrich SP06 - Ventilating Your Rooms

Ventilating Your Room i
ff the air in your room is stale, you can ven_late the room using the Fan feature.
Ifyou wish to discharge stale air, push the ventilation lever on the front of the
unit to the right and open position ( _ ).
• The air inside the room circulates and stale air is discharged
outside.
Otherwise, push the ventilation lever to the lelt and closed position ( "a" ).
• The air simply circulates inside the room.
if necessary, press the (I) (OnlOff) button.
Result: • The air conditioner starts up in the mode selected when
the unit was last used.
• The unit beeps.
if the _ is not displayed at the top of the remote control,
press the _ button on the remote control one or more times until it
appears,
Result: • The unitbeepseach timeyou pressthe _ button.
• The airconditionerruns inthe Fanmode.
• The temperatureis setautomatically.
You can change modes at any time.
Select the fan speed by pressing the _ button one or more times
until the required setting is displayed:
%%n Low
n"_4nI Medium
_4n I | High
Result: Each time you press the _ button, the unit beeps,
___________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________5 To control the direction of the air flow, refer to page 20,
_________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________