i Removing Excess Humidity
ff the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
If necessary, press the (_ (OnlOff) button.
Result: • The air conditioner starts up in the mode selected when
the unit was last used.
• The unit beeps.
JIl"
The air conditioner is fitted with a protection mechanism
to prevent the unit from being damaged when it is started
immediately after being:
• Plugged in
• Stopped
It will start up normally after three minutes.
If the (_ is not displayed at the top of the remote control, press the
button on the remote control one or more times until it appears.
Result: • The unitbeepseach timeyou press the _ button.
• The air conditionerruns in the Dry mode.
You can change modes at any time,
To adjust the temperature, press the _ buttons one or more times
until the required temperature is displayed.
The temperature can be set between 64°F and 86°F.
Result: • Each time you press the _ buttons:
- The temperature is adjusted by I°F
- The unit beeps
• The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
4 To control the direction of the air flow, refer to page 20,
To Next Page
Loading...
