Press the upper scroll arrow once for the ‘Go to dock’ option and press ‘GO’.
Walk along the side of the Robomow while it is following the edge. At any point where the mower position
is too far to the outer edge of the lawn area, note this area and slightly move the wire towards the interior.
For example, if the bumper of the mower is hitting the wall of your home while trying to mow the edge, the
wire is too close to this edge and needs to be positioned more towards the interior of the lawn, and away
from the wall. Conversely, if the mower is not mowing close enough to fixed objects like walls or fully onto
adjacent and level areas such as a driveway, the wire needs to be positioned farther from the interior of the
lawn, out towards the wall or driveway. Reposition the wire along each section where a change needs to
be made, usually moving it only a little each time, and then test the edge mowing in this area once again.
Repeat this process for the entire edge until it can complete the perimeter without striking any object and
you are satisfied with the cutting distance over onto adjacent level areas.
Once complete, walk back along the perimeter and add in wire pegs to those areas of the wire where it is
not pulled down below the level of the grass tips and close to ground level. This is the time to inspect the
whole wire installation for tripping hazard. Any place the wire is raised or loose should be tightened and
pegged down with extra wire pegs. Purchase extra pegs if needed.
Position the Robomow
towards the wire, after the
Charging station
Fi
ure 2.12
Testin
the Perimeter Wire Position
37
To Next Page
Loading...
