Message
Displayed
Probable Cause/Event
Corrective/User Action
Skipped: Low
bat
- Robomow has skipped the last depart due to low
battery voltage
- Confirm there is enough time between the two
adjacent departures so the battery can be
charged prior the scheduled operation (min 16
hours between operations)
Skipped: Rain
(Only Enhanced
Manual
Controller)
- Robomow has skipped the last depart due to rain
detection
- It is not recommended to cut wet or damp
grass, but if you choose to override the rain
sensor, change the setting of the ‘Rain sensor’
to ‘off’ under the ‘User preferences’ menu.
- An unknown fault has occurred and user help is
required
- Manually drive the mower away from this
particular area and restart operation
Start Elsewhere
- Wheel drive motors have been working under a
severe load
- Check to insure the mower is not stuck,
allowing the wheels to slip
Thermistors fail
- Faulty / disconnected thermistors (overheat
protection)
- Contact service provider
Time Completed
- The operating time set for that zone has been
reached
- Connect to the charger if all mowing has been
completed for the day.
Waiting for
signal…
- Robomow has stopped the operation in Dock zone,
because there is no signal received from the
Charging Station
- Check the power to the Charging Station.
- There is electrical power interruption. There is
no need to do anything – Robomow will renew
automatically the operation if the power will
come back within an hour from the break.
7.2 Other Operational or Fault Problems
Problem Encountered
Probable Cause/Event
Corrective/User Action
- In general, wheneverthe mower does not depart at the scheduled time, the causet is
recorded under ‘Weekly Program Display’
(refer to section 4.4 for more details).
- Confirm thatthe time in the mower is
set correctly (day and hour)
- Set the time (See paragraph 4.1)
- Low battery voltage
- Confirm there are minimum 16 hours of
charging in the Charging Station before the
next scheduled depart
Robomow does not leave the
Charging Station for operation
at the time set in the Weekly
Program
- ‘Auto depart’ is set to ‘off’ (‘Manual
depart’ is displayed when the mower
is in the Charging Station)
- Change the setting of the ‘Auto depart’ to ‘on’
(See paragraph 6.3)
Robomow does not detect the
Charging Station contacts
and/or ‘Front wheel problem’
is displayed when the mower
is in the Charging Station
- Power supply/charger is not
plugged into the main power supply
- Confirm power supply is plugged into the main
power receptacle.
Robomow reached the
Charging Station when its
contacts are above the
Charging Station contacts
- Height difference between the
Charging Station base and the lawn
surface at the entrance to the
Charging Station
- Confirm the ground before the Charging
Station is leveled with the Charging Station
base – if necessary fill the area with dirt and
level off
Robomow does not complete
the edge in plot with Charging
Station
- Power cables or magnetic
interference caused the mower to
leave the wire before reaching the
Charging Station.
- Call service to confirm ‘Edge to dock’ is set to
‘on’ under the service menu.
63
To Next Page
Loading...
