4.2 Filling/refilling the store with fuel
When filling the store you should always ensure that you are using the right fuel:
Permitted fuels
4.2.1 Loading of fuel for a partially emptied store with rotary agitator
If there is still sufficient fuel in the store (the head of the rotary agitator is completely
covered with fuel and the rotary agitator arms are not extended), the store can be
filled:
❒
Load the fuel at the filling opening
4.2.2 Loading wood chips in an empty store (not under pressure)
NOTICE! If the head of the rotary agitator is already free of material and the arms /
spring blades are extended, the feeder unit must be active during the filling process.
❒
Activate “Extra heating” mode in the quick selection menu
Exception in the case of a separate drive:
❒ Tap “On” in “Bunker filling rotary agitator” during manual operation
➥ The rotary agitator head runs for approx. 3 minutes
❒ Load a small quantity of wood chips and wait until the arms / spring blades are
touching the head of the rotary agitator (approx. 2 revolutions)
❒ Only then should you load the remaining material
Operating the System
4
Filling/refilling the store with fuel
Operating Instructions T4e | B1560520_en 25
To Next Page
Loading...
Need help?
General
