H Access all system information. No parameters may be changed in the info menu.
I System menu for opening the system settings. All parameters can be displayed and/or
edited depending on the user level.
⇨ See "Navigation within the system menu" [page
32]
J Display and change the current boiler mode
⇨ See "Change boiler mode" [page
38]
K Display icons for using froeling-connect
⇨ See "Display icons for froeling-connect/remote control" [page
31]
L Brightness sensor for automatically adjusting the brightness of the display
M LED frame to display the current system status
⇨ See "Status display" [page 30]
N USB interface for software update (➾ see operating instructions for the boiler
controller)
NOTICE! USB interface is for service purposes only and must not be used to load
devices or for PC connections!
Status display
The status display indicates the system’s operating status:
▪ Constant in the set colour: SWITCHED ON
Boiler in an error-free operating state (standby, heating, …)
Set colour can be changed using the setting wizard “Switching on for the first time”
▪ ORANGE flashing: WARNING
▪ RED flashing: FAULT
Control icons
Confirms values entered; activates parameters
Discards any values entered without saving; and closes messages
Back to basic display
Accesses all system information
Opens quick menu. Selection of functions depending on user level, configuration
and current status.
Tap to change parameters (dropdown menu or numeric keypad)
4
Operating the System
Operate the boiler using the touch display
30 Froling GesmbH | A-4710 Grieskirchen, Industriestraße 12 | www.froeling.com
To Next Page
Loading...
Need help?
General
