Why does my Froling P2-15 Boiler show a 'Stoker error'?
A 'Stoker error' on your Froling Boiler means the gravity shaft level sensor still detects material after 10 minutes of stoker operation. This may be caused by a fuel bridge in the gravity shaft, an incorrectly set sensor, or the stoker not feeding. Break up any fuel bridges, readjust the sensor, and check the stoker drive.
What to do if Froling P2-15 says 'Door open - Empty ash box'?
If the Froling Boiler displays 'Door open - Empty ash box', it means the insulating doors have been open for over 10 minutes during heating, the door contact switch isn't closing, or the ash box is full. To resolve this, check or adjust the switch, ensure the insulating doors are closed properly, and empty the ash box.
How to fix a Froling P2-15 Boiler with nothing on the display?
If nothing is showing on the Froling Boiler's display, it could be due to a general power failure, a tripped FI circuit breaker, the main switch being off, or a defective fuse. To fix this, switch on the FI circuit breaker, turn on the main switch, or replace the fuse (10AT).
What to do if my Froling Boiler says 'Check storage room'?
If your Froling Boiler displays 'Check storage room', it indicates that the MAX sensor wasn't reached after 10 minutes of suction. This could be due to no pellets in the suction probe, a blockage in the hose, or a faulty sensor. Refill pellets, remove any blockages, and readjust the sensor. Also, check the plug connection to the motor.
What to do when Froling Boiler says 'Clean /check burner'?
The 'Clean/check burner' message on your Froling Boiler signals successful automatic troubleshooting. Acknowledge the warning, then open the insulating and combustion chamber doors. Clean embers, fuel, and slag from the pellet burner. Clean the flue gas guide in the boiler up to the chimney mouth, and empty the ash drawer.
Critical safety warnings regarding non-permitted use, external influences, and hot surfaces.
Details safety devices and mechanisms to prevent boiler overheating.
Guidelines for safe installation environments and steps for emergencies like fire or overheating.
Configuration of essential system parameters including temperatures, times, and operational settings.
Step-by-step guide for inspecting and cleaning key boiler components like the burner and ash system.
Comprehensive checklist for annual servicing of heat exchangers, sensors, fans, and flue systems.
Comprehensive guide for initial startup, operating levels, system type, and parameter settings.
Detailed listing and explanation of all configurable parameters for the control system.
To Next Page
General