To Next Page

To Previous Page

Troubleshooting

Fröling Heizkessel- und Behälterbau Ges.m.b.H, Industriestraße 12, A-4710 Grieskirchen, Austria Page 41

Tel +43 (0) 7248 606-0 Fax +43 (0) 7248 606-600 info@froeling.com www.froeling.com

B0190806

6.4 Error message list

Error texts in alphabetical order:

Error text Code

Type

Cause of error Error correction

Outdoor sensor temp.

false

036 W • Sensor signal damaged  Check sensor and sensor cable

DHW temp. false 006 W • Sensor signal damaged  Check sensor and sensor cable

DHW temp.2 false 037 W • Sensor signal damaged  Check sensor and sensor cable

Clean /check burner 049 W Signals successful automatic troubleshooting

NOTE: can only be cleared by checking and cleaning the burner

 Acknowledge warning

 After you have done this, open the insulating door and

combustion chamber door

 Clean embers, fuel and slag from the pellet burner (see

chapter on maintenance)

 Clean the flue gas guide in the boiler up to the mouth of the

chimney

 Empty the ash drawer

Stoker error 030 F Gravity shaft level sensor still

recognises material after 10

minutes of stoker running

time:

• Bridge formation in the

gravity shaft

• Sensor incorrectly set

• Stoker not feeding

 Break up the bridge of fuel,

remove foreign bodies if

necessary

 Readjust the sensor

 Check stoker drive

Remote control 1 error 004 W • Sensor signal damaged  Check sensor and sensor cable

Remote control 2 error 005 W • Sensor signal damaged  Check sensor and sensor cable

Remote control 3 error 025 W • Sensor signal damaged  Check sensor and sensor cable

Remote control 4 error 026 W • Sensor signal damaged  Check sensor and sensor cable

Froling P2-15 User Manual

Questions and Answers: