4.4.1 Settings menu
In the “Settings” operating menu the most important parameters and
values for the system can be changed:
Setting boiler temperature
Boiler temp. ... Boiler temp. should be 80°C The boiler temperature is regulated to this
temperature
Set storage tank temperatures
Storage tank ... Storage temp. heat
circ. launch 30°C
Only for systems with storage tanks
Minimum temperature for releasing the
heating circuit. (Sensor 1)
Store up. min. temp. 60°C Upper store temperature, below which the
boiler is started in transitional operation.
Set DHW tank temperatures
DHW tank ... Set DHW temp 55°C When the specified temperature is reached
in the DHW tank, the DHW tank loading
pump switches off.
Desired DHW tank 2
temperature 60°C
When the specified temperature is reached
in DHW tank 2, DHW tank loading pump 2
switches off.
Reload when the DHW
tank is below 45°C
Reloading of the DHW tank is authorised
when the DHW tank temperature is below
this level.
Reload when the DHW
tank is below 45°C
Reloading of the second DHW boiler is
authorised when the DHW boiler
temperature is below this level.
Start of 1st loading 05:00 Start of authorisation for 1st DHW tank
loading session
End of 1st loading 08:00 End of authorisation for 1st DHW tank
loading session
Start of 2nd loading 15:00 Start of authorisation for 2nd DHW tank
loading session
End of 2nd loading 18:00 End of authorisation for 2nd DHW tank
loading session
Only heat once a day N “Y” prevents heating up several times in
one day
Legionella heating 65° Y The DHW tank is heated to at least 65°C
once a week
Legionella heating day Mo Day of the week for Legionella heating.
To Next Page
Loading...
Need help?
General
