35
EN
Control elements and connections
Safety
Connections and
mechanical com-
ponents
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
NOTE! Due to software updates, you may find that your device has certain func-
tions that are not described in these operating instructions or vice versa. Individ-
ual illustrations may also differ slightly from the actual controls on your device, but
these controls function in exactly the same way.
(1) (-) current socket
with bayonet latch
(2) (+) current socket
with bayonet latch
(3) Charger connection
(4) Air filter
The use of the current connections depends on the welding process:
- MMA welding (depending on electrode type)
(+) current socket for electrode holder or grounding cable
(-) current socket for electrode holder or grounding cable
- TIG welding
(+) current socket for grounding cable
(-) current socket for welding torch
(1)
(2)
(3)
(4)
To Next Page
Loading...
