62
Warning notices
inside the device
Proper use The charger is designed to charge the power sources listed below. Any use above and be-
yond this purpose is deemed improper. The manufacturer shall not be liable for any dam-
age resulting from such improper use. Proper use also includes:
- carefully reading these operating instructions
- following all the instructions and safety rules in these operating instructions
The following power sources may be charged:
- Fronius AccuPocket 150/400
- Fronius AccuPocket 150/400 TIG
An electric shock can be fatal. Do not open the device!
The housing must never be opened by anyone other than a Fronius-trained ser-
vice engineer. The device must be disconnected from the mains before starting
any work with the housing open. A suitable measuring instrument must be used
to ensure that electrically charged components (e.g. capacitors) are fully dis-
charged. Ensure that the device remains disconnected from the mains until all
work has been completed.
This warning sign is located inside the de-
vice. It must NOT be removed or painted
over.
The discharge time of the capacitors is ap-
prox. one minute.
Entladezeit > 5 sek.
Discharge time > 5 sec.
Temps de décharge > 5 s
WARNING! Charging any other devices can cause serious injury or damage, and
is therefore prohibited.
The charger is intended solely for commercial use.
To Next Page
Loading...
