Fronius AccuPocket 150/400 - MMA Welding Procedures

38
MMA welding
Preparatory work Press the On/Off button for at least two seconds to turn off the power source
- the indicators go out
Plug the grounding cable into the (+) or (-) current socket depending on which type of
electrode is to be used and turn it clockwise to latch it in place
Use the other end of the grounding cable to establish a connection to the workpiece
Plug the electrode holder into the (+) or (-) current socket depending on which type of
electrode is to be used and turn it clockwise to latch it in place
Insert the rod electrode into the electrode holder
Press the On/Off button for at least two seconds to turn on the power source
- the welding current indicator lights up
- the display shows the specified welding current
MMA welding Use the welding process button to select one of the following processes:
MMA welding - the MMA welding indicator lights up after selection
MMA welding with Cel electrode - the MMA welding with Cel electrode
indicator lights up after selection
Press the setting value button until
the welding current indicator lights up
Select the amperage using the adjusting dial
- Power source is ready for welding
SoftStart / Hot-
Start function
This function is used to set the starting current.
Setting range: 0 - 200%
Operating principle:
At the start of the welding process, the welding current is reduced (SoftStart) or increased
(HotStart) for 0.5 seconds, depending on the setting.
The change is shown as a percentage from the set welding current.
The duration of the starting current can be changed in the Setup menu using the Hti pa-
rameter, see Starting current duration on page 45.
Setting the starting current:
Press the setting value button until
the SoftStart / HotStart indicator lights up
Turn the adjusting dial until the desired value is reached
- Power source is ready for welding
CAUTION! Risk of injury and damage from electric shock. As soon as the
power source is switched on, the electrode in the electrode holder is live.
Make sure the electrode does not touch any persons or electrically conduc-
tive or earthed parts (e.g. the housing, etc.).
1
2
3
4
5
6
1
2
3
1
2