Fronius IG-TL 3.6 - Attaching the Wall Bracket - Column Installation

30
Attaching the wall
bracket - Column
installation
CAUTION! The inverter can be damaged by soiling or water on the terminals and
contacts of the connection area.
- When drilling, make sure that terminals and contacts in the connection area
do not become soiled or wet. Leave the dust cover in position.
- The wall bracket without the power stage set does not possess the same de-
gree of protection as the complete inverter and, therefore, should not be at-
tached without a power stage set.
Protect the wall bracket from soiling and moisture during installation.
min. 50 mm
min. 2 in.
1
1
2
3
(*)
1
1
2
2
IMPORTANT! Attach the wall bracket so that the display marking (*) on the wall bracket is
at eye level.
NOTE! When attaching the wall bracket to the wall, make sure that the wall brack-
et is not warped or deformed.
2
3
1
1
3
3
4
1
2
4
1
4