72
Menu Items in the Setup Menu
Standby Manual activation/deactivation of the standby mode
- The power electronics are switched off in standby mode. No power is fed into the grid.
- The Startup LED lights up orange.
- In standby mode, no other menu item can be accessed or set in the Setup menu.
- Automatic switching to the ‘NOW’ display mode after 2 minutes if no key is pressed is
not activated.
- The standby mode can only be deactivated manually by pressing the ‘Enter’ key.
- Grid supply operation can be resumed at any time (deactivate ‘Standby’).
Setting standby mode (manual shutoff for feeding energy into the grid):
Select the ‘Standby’ menu item.
Press the ‘Enter’ key.
The display alternates between ‘STANDBY’ and ‘ENTER.’
The Standby mode is now activated.
The Startup LED lights up orange.
Restoring the grid feed:
In Standby mode, the display alternates between ‘STANDBY’ and ‘ENTER.’
Press ‘Enter’ to restore the grid feed.
The menu item ‘Standby’ is shown.
The inverter also switches to the Startup phase.
After the grid feed is restored, the Operation Status LED lights up green.
Contrast Contrast setting on LCD display
Since contrast depends on temperature, it may be necessary to adjust the ‘Contrast’ menu
item when ambient conditions change.
Unit -
Setting range Enter
Factory setting ‘Standby’ deactivated
To Next Page
Loading...
