41
- Place the housing cover at an angle on
the power stage set so that there is an
opening at the bottom of the power
stage set
- Reach into the opening
- Connect the ribbon cable to the display
PC board
NOTE!
- Use pliers to insert fuses with a fuse cover into their respective fuse holder
- To prevent the fuse from falling out, only insert the fuse cover into the fuse
holder with the opening upright.
- Do not operate the inverter without fuse covers
2
1
1
4
3
3
5
* Tightening torque: 2.5 Nm
IMPORTANT! Check the polarity of solar module strings!
1
2
*
6
To Next Page
Loading...
