Fronius KD Supply 2500 - Fitting the KD Supply 2500 to the Trolley; General Remarks; Fitting the KD Supply 2500 to the Base of the Trolley

10
Fitting the KD Supply 2500 to the trolley
General remarks The welding system can be fitted to a trolley to increase the mobility of the system.
IMPORTANT!
If the welding system is not equipped with an auto-transformer or a cooling unit, the
KD Supply 2500 must be installed right at the bottom.
► If a cooling unit is present, fit it right at the bottom and place the KD Supply on top of it.
Fitting the KD
Supply 2500 to
the base of the
trolley
If there are no fastening brackets on
the trolley:
Attach two fastening brackets to the
base of the trolley and secure each
one using three „Extrude-Tite“ screws.
Place the KD Supply 2500 on the base
of the trolley.
Using „Extrude-Tite“ screws, fasten the
KD Supply 2500 at the front and back
to the fastening brackets on the base
of the trolley.
1
2
3