7
EN
General
Machine concept
KD Supply 2500
The KD Supply 2500 enables the TIG pow-
er sources TT 2500 / 3000 Job and MW
2500 / 3000 Job to be used with a cold wire
feeder. The built-in switchedmode power
supply supplies the feeder motor.
The KD Supply 2500 simultaneously func-
tions as an active LocalNet distributor. In
addition to providing an interface to the cold
wire feeder, the KD Supply 2500 also has
an additional LocalNet interface, e.g. for a
remote control unit.
Safety symbols
on the rating plate
The KD Supply 2500 has safety symbols on the rating plate. The safety symbols must NOT
be removed or painted over. The symbols warn against operating the equipment incorrect-
ly, which can cause serious injury and damage.
Welding is dangerous. The following basic requirements must be met:
- Welders must be sufficiently qualified
- Suitable protective equipment
- Keep all persons not involved in the welding process at a safe distance
Do not use the functions described here until you have read and completely
understood all of the following documents:
- these Operating Instructions
- all the Operating Instructions for the system components, especially the
safety regulations
To Next Page
Loading...
