Fronius Primo 5.0-1 - Page 122

122
Remove 4 x 4x9 mm TX20 screws (3)
and remove the disconnector from the
wall bracket.
Installing the DC Disconnector:
Insert the disconnector into the wall
bracket and fix with 4 x 4x9 mm TX20
screws (3)
Tightening torque = 2 Nm.
IMPORTANT! When inserting the shift
knob with shaft pay attention to the
openings.
Insert shift knob with shaft (2) through
the housing. (Position 0)
(3)
(3)(3)
(3)
3
(3)
(3)(3)
(3)
1
(2)
3
2