138
Remount the grounding connection for
plug-in cards (10) in the housing base
shell
Bend the grounding lug (11) back
Reinsert the PC board holder (8).
Re-attach the ferrite cores (5) & (7) in
the divider
Restore all the cable connections (1)–
(7)
Final Tasks Reinsert RECERBO PC board and check that it is correctly seated.
If installed, reinsert option cards (for example the Datamanager card).
If the female connectors are present and have not yet been connected with the rest of
the data communication cables and terminating plugs:
Plug in female connectors
Insert the external fan cable into the RECERBO cable guide
Attach the power module cover
Insert the device into the wall bracket and tighten screws
If applicable connect the data communication lines
Attach the DATCOM cover
Reconnect the AC power supply
Set the DC disconnector to ON
After commissioning the inverter, start a fan test via the display (see operating instruc-
tions)
(10) (10)
4
5
6
7
8
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...
