59
EN-US
Options
Options
OPTION
‘ShadeCover’
- Use the ShadeCover when the inverter
is exposed to direct sunlight
- Use 4 screws for proper mounting
4.75 in.
120 mm
4 in.
100 mm
2.75 in.
70 mm
NOTE! A DIN rail is provided in
order to mount accessory electri-
cal devices including, but not limit-
ed to, overcurrent protection,
metering, radio or cellular modem.
Maximum size for mounting of all
devices is 4 w x 4.75 l x
2.75 inches. The installer takes re-
sponsibility for any undesired ef-
fect on the inverter by installing an
electrical device in this area. Cau-
tion should be taken when install-
ing a device that may output
significant amounts of heat or ra-
dio interference. Always ensure
that the device does not inhibit the
inverter from closing and sealing
properly. Any questions about de-
vice eligibility should be directed
toward technical support.
1202817,1*
To Next Page
Loading...
