8
Fasten the screws of the cable guide to
the housing using a screwdriver (TX20)
and tighten to a torque of 1.3-1.5 Nm.
NOTE!
Risk due to overtorque at the strain-
relief device.
This may result in damage to the
strain-relief device.
▶
Do not use a drill driver.
IMPORTANT!
Information for connection on the battery side can be found in the Installation
Instructions from the relevant manufacturer.
Connecting the
LG FLEX ground
conductor
1
Route the battery ground conductor
into the integrated cable duct of the
connection area divider and into the
AC connection area.
2
Fasten the battery ground conductor
to the second input of the ground
electrode terminal from the top using
a screwdriver (TX20) and a torque of
1.8 – 2 Nm.
IMPORTANT!
Information for connection on the battery side can be found in the Installation
Instructions from the relevant manufacturer.
82
To Next Page
Loading...
