Installation using the Solar.web app
2
Download the Fronius Solar.web
App
3
Run the Fronius Solar.web app
Installation using a web browser
2
Connect the end device to the
WLAN access point
SSID = FRONIUS_239.xxxxx (4-8
digits)
- Search for a network with the
name "FRONIUS_239.xxxxx"
- Establish a connection to this
network
- Enter the password 12345678
(Alternatively, connect the end
device and inverter using an Ether-
net cable.)
3
Enter the following in the browser:
http://datamanager
or
192.168.250.181 (IP address for
WLAN connection)
or
169.254.0.180 (IP address for LAN
connection)
The Setup wizard start page is displayed.
If you run the technician wizard, always remember to make a note of the assigned ser-
vice password. This service password is required to enter settings in the "System over-
view" and "DNO Editor" menus as well as for advanced battery settings.
If the technician wizard is not run, no specifications regarding power reduction are set
and hybrid mode is not possible (charging and discharging of the battery)
4
Run the technician wizard and follow the instructions
75
EN
To Next Page
Loading...
