Installing Fronius system monitoring – Overview
Safety
WARNING!
Danger from incorrect operation
This can result in severe personal injury and damage to property.
▶
Do not use the functions described here until you have fully read and understood the
Operating Instructions of every system component:
▶
Do not use the functions described here until you have read and understood all the
safety rules.
IMPORTANT! Knowledge of networking systems is required in order to install Fronius
system monitoring.
Starting for the
first time
IMPORTANT! Starting up the Fronius system monitoring function for the first time is
made considerably easier with the Fronius Solar.web app. The Fronius Solar.web app is
available in the respective app stores.
Or visit
https://wizard.solarweb.com to select the desired menu item
IMPORTANT! In order to establish a connection to Fronius system monitoring, the end
device in question (e.g. laptop, tablet, etc.) must be set up as follows:
- "Obtain IP address automatically (DHCP)" must be activated
1
Switch the device to Service mode
- Activate the WLAN Access Point via the Setup menu on the inverter
Relay
Standby
WiFi Access Point
Relay
Clock
Display Setting
The inverter establishes the WLAN access point. The WLAN access point remains open
for 1 hour.
74
To Next Page
Loading...
