Fronius TransPuls Synergic 3200 - Changing Shunt (TPS 2700); Removing Shunt

103
EN
Changing shunt (TPS 2700)
Removing shunt
Fig.1 Screws on the front aperture
Fig.2 Loosening the drive unit
Fig.3 Removing the drive unit
1. Open wire-feed unit cover
2. Remove side panel
3. Loosen two screws (1) on front
aperture
1. Loosen two screws (3) on the drive
unit (2)
NOTE! When lifting the drive unit
(2), do not pinch, bend or strain
the cables.
2. Carefully raise the entire drive unit (2)
1. Loosen 2-pin Molex plug connection (4)
2. Carefully place the entire drive unit (2) to one side
(1)
(2)
(3)
(2)
(4)