80
Plug layout
(continued)
Pin function
X1 Connection to control panel
Pin 1 GND for power potentiometer
Pin 2 +5 V for power potentiometer
Pin 3 Power+ (actual value of power
potentiometer)
Pin 4 Power - (clip on pin 1 with
potentiometer)
Pin 5 GND (arc correction)
Pin 6 +5 V (arc correction
Pin 7 ARC-CORR + (arc correction
actual value)
Pin 8 ARC-CORR - (clip on pin 5 with
potentiometer)
Pins 3/4 and 7/8 with differential amplifier
X2 LocalNet connection to control panel (ribbon cable)
Pin 1 -15 V
Pin 3 GND D
Pin 5 +5 V
Pin 7 RXDL
Pin 9 TXDL
Pin 2 +15 V
Pin 4 +5 V
Pin 6 GND D
Pin 8 RXDH
Pin 10 TXDH
X3 Welding torch control
Pin 1 Gun Trigger Euro
Pin 2 +5 V PullMig potentiometer
Pin 3 PM LSP (PullMig potentiometer
actual value)
Pin 4 UP / DOWN (+ 5 V = up,
0 V = down, 2.5 V = no buttons
pressed)
Pin 5 Gun Trigger - torch trigger
Pin 6 GND D Euro
Pin 7 GND Pullmig potentiometer
Pin 8 Torch detection
Pin 9 GND torch
Pin 10 +15 V
X4 Robot sensors/feeder inching and gas test
Pin 1 Torch blow out
Pin 2 I on - current flow signal
Pin 3 Wire retract
Pin 4 Wire in
Pin 5 Wire end
Pin 6 Gas pressure watchdog
Pin 7 KAT - cut-out box
Pin 8 +24 V torch blow out
Pin 9 +24 V (res)
Pin 10 Gas test
Pin 11 GND to pin 3/4/6/10/12
Pin 12 Real value - actual rotational
speed value
Pin 13 GND wire end
Pin 14 GND cut-out box
X5 Actual rotational speed value, gas solenoid valve and configuration memory
Pin 1 GND actual rotational speed
value
Pin 2 VD-ANA - (wire buffer sensor)
Pin 3 CFM-
Pin 4 +24 V gas solenoid valve
Pin 5 Actual rotational speed value in
Pin 6 VD-ANA + (wire buffer sensor,
0-5 V)
Pin 7 CFM +
Pin 8 Gas solenoid valve
X6 LocalNet connection for remote control
Pin 1 +24 V
Pin 2 RXDL-RC
Pin 3 RXDH-RC
Pin 4 GND
Pin 5 TXDL-RC
Pin 6 TXDH-RC
To Next Page
Loading...
