EasyJob mode
General The "Save" buttons allow up to five EasyJob operating points to be saved. Each operat-
ing point corresponds to the settings made on the control panel.
EasyJobs can be stored for each welding process.
IMPORTANT! Setup parameters are not saved at this time.
Saving EasyJob
operating points
1
Press and hold one of the "Save" buttons to save the current settings on the control
panel, e.g.
- The left display reads "Pro"
- After a short time, the left display switches to the original value
2
Release the "Save" button
Retrieving Easy-
Job operating
points
1
To retrieve saved settings, press the corresponding "Save" button briefly, e.g.
- The control panel will show the saved settings
Deleting EasyJob
operating points
1
Press and hold the relevant "Save" button to delete the memory content of that
"Save" button, e.g.
- The left display reads "Pro".
- After a short time, the left display switches to the original value
2
Keep the "Save" button held down
- The left display reads "CLr".
- After a while, both displays show "---"
3
Release the "Save" button
77
EN-US
To Next Page
Loading...
Need help?
General
