- Press the adjusting dial
The image for the currently selected mode is shown, e.g.:
TIG welding parameters for 2-step mode
Basic setting
parameters
"Minimum" and "maximum" are used for setting ranges that differ according to power
source, cold wire-feed unit, welding program, etc.
Language
Unit -
Setting range D / GB / F / I / E / CZ / S / P / NL / PL
Factory setting D
D German E Spanish NL Dutch
GB English CZ Czech PL Polish
F French S Swedish
I Italian P Brazilian Portuguese
Unit
Setting determines whether metric or imperial units are shown
Unit -
Setting range metr./imperial
Factory setting metr.
metr. Metric units (e.g. mm, m/min, l/min, etc.)
imperial Imperial units (e.g. in., ipm, cfh, etc.)
Contrast
For setting the display contrast
Unit %
Setting range 0 - 100
Factory setting 20
Factory
For resetting the welding machine
See the "Factory - resetting the welding machine" section for further details.
169
EN
To Next Page
Loading...
Need help?
General
