General
Device concept
VR 4000/VR 4000-30 wire-feed unit
VR 4000-30 TIME wire-feed unit
The wire-feed units are designed to be used with wirespools of max. 300 mm
(11.81 in) diameter. The standard 4-roller drive has good wirefeeding properties.
The wirefeeders are also suitable for long hosepacks. Due to their compact size,
the wirefeeders can be used in many different ways.
The VR 4000-30 TIME wire-feed unit is specially designed for the TIME high-per-
formance welding process. All the important TIME process functions can be set
directly on the wire-feed unit control panel using the integrated 3-parameter
control. The following functions are not available:
-
MIG/MAG standard manual welding
-
Job mode
-
LocalNet connection (e.g. operation with remote control or JobMaster weld-
ing torch)
REQUIRE-
MENTS
To operate the wirefeeder, it must first be configured for use with the corres-
ponding power source:
VR
4000
VR
4000-30
VR 4000-30
TIME
TransSynergic 4000/5000 X X -
TransSynergic 7200/9000 X X -
TransPuls Synergic
3200/4000/5000
X X -
TransPuls Synergic 7200/9000 X X -
TIME 5000 Digital - X X
TransPuls Synergic 2700 Duo X - -
TransPuls Synergic 2700 Duo TIG X - -
18
To Next Page
Loading...
