Fronius VR 4000 - Controls and Indicators; General; Standard Control Panel

Controls and indicators
General
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
Do not use the functions described here until you have fully read and understood
the following documents:
▶
These operating instructions
▶
all the operating instructions for the system components, especially the
safety rules
Setting parameters at control panels is only possible in manual welding mode.
In the automated welding mode or in robot welding, the robot control provides
the set values for the welding parameters. Specifying command values via con-
trol panels is not possible in automated welding mode or in robot welding.
IMPORTANT!
Welding parameters that must be entered on a wire-feed unit control panel can-
not be changed on the power source.
Welding parameters can only be changed on the wire-feed unit.
Standard control
panel
(1)
(2)
Standard control panel
(1) Welding power/wire speed ad-
juster
-
Setting the welding power
(during MIG/MAG pulse syn-
ergic welding, MIG/MAG
standard synergic welding)
-
Setting the wire speed
(during MIG/MAG standard
manual welding)
22