Application area
-
VR 4000: for all types of MIG/MAG welding
-
VR 4000-30: primarily used with TS/TPS 7200 and TS/TPS 9000 high-per-
formance power sources. In conjunction with the TR 2100 remote control,
and also with the TIME 5000 Digital power source
-
VR 4000-30 TIME: in conjunction with the TIME 5000 Digital high-perform-
ance power source, for all types of MIG/MAG high-performance welding
All variants of the VR 4000 are suitable for all standard shielding gases.
NOTE!
The VR 4000 - 30 and VR 4000-30 TIME wire-feed units have a water-cooled
electric motor with disc-shaped rotor, and may only be operated in conjunction
with an appropriate cooling unit.
Warning notices
on the device
The wire-feed unit has safety symbols on the rating plate. The safety symbols
must not be removed or painted over. The symbols warn against operating the
equipment incorrectly, as this may result in serious injury and damage.
Do not use the functions described here until you have fully read and
understood the following documents:
-
These operating instructions
-
all the operating instructions for the system components, espe-
cially the safety rules
Welding is dangerous. The following basic requirements must be met:
-
welders must be sufficiently qualified
-
use appropriate protective equipment
-
all persons not involved in the welding process must be kept at a
safe distance
19
EN
To Next Page
Loading...
