Fronius VR 4000 - Placing Wire-Feed Unit on Power Source; General

Placing wire-feed unit on power source
General The wire-feed units can be placed on the power source if a swivel pin holder is
available, e.g.:
-
"PickUp" swivel pin receptor, for use with the "PickUp" trolley
-
"narrow" swivel pin receptor, for use with an upright console
-
"wide" swivel pin receptor, for use with two screwed upright consoles and two
power sources
More detailed information on the swivel pin receptors can be found in the "Swivel
pin receptors for upright consoles" and "PickUp" operating instructions.
General
CAUTION!
Danger from falling wire-feed unit.
Check that the wirefeeder is securely placed on the swivel pin.
1
2
28