Caller ID on TV
Alerts will display while you are watching live and recorded shows, looking at the
guide and playing games.
4.6 Caller ID Block
Caller ID Block allows you to block your telephone number from being displayed on
the phone or Caller ID device of the person you are calling on a per-call basis or for all
calls.
Note: Remember that the person you are calling may not accept unidentified calls
.
TV
To activate Caller ID on your Fiber TV:
1. Using your Fiber TV set-top box remote, press the Menu button.
2. Arrow to Settings and press OK.
3. Arrow to System.
4. Arrow to Notifications.
5. Arrow to Caller ID.
6. Arrow to Check Availability and press OK.
7. A message will confirm that Caller ID is available. It can take up to 24 hours to
activate.
Note: Caller ID on TV cannot be enabled for about 24 hours after your Fiber Digital
Voice order completes
.
You will receive a message on the screen to check back later if
you recently ordered service.
Customizing your Caller ID on TV:
From the Caller ID menu, you can:
• Choose how long alerts display (2, 5, 10 or 15 seconds)
• Where alerts display (top left, bottom left or bottom right)
To stop/disable the display of Caller ID on your TV:
1. Using your Fiber TV set-top box remote, press the Menu button.
2. Arrow to Settings and press OK.
3. Arrow to System.
4. Arrow to Notifications.
5. Arrow to Caller ID.
6. Arrow to Alert Display.
7. Select Disable and press OK to stop the display of Caller ID on your TV.
To Next Page
Loading...