14
11. Now define the IP address of this CB2000. Select Ethernet from the left-hand menu
12. Change the IP address, subnet mask, and router IP address to the appropriate values for this CB2000
(Reference your Installer Planning Template; see Step 1)
13. Click Save Settings (your browser will likely timeout; this is normal)
8. Select Time from the left-hand menu
9. Click Load Computer Time
10. Click Save Settings
14. Disconnect the CB2000 from the Cat 5 cable, replace it in its anti-static bag, and apply a label with the
room number written on it so you are sure to install it in the right place on the job site.
15. Connect your next CB2000 and repeat Step 3.4 ‘Load the Configuration’ until all of your units are
programmed. Note that on some Windows
®
computers, you may need to clear the ARP cache in order
to communicate with the next device. See Appendix F.
To Next Page
Loading...