15
Nearly everything you need to install your FrontRow CB2000s is included in the boxes we shipped.
You will need some basic tools and materials, depending on how your classroom is built:
1. Materials you will need
• For each CB2000: US-standard single-gang (or, if using the CB50 volume control, double-gang)
AV box, electrical box, surface box, or mud ring
• Plastic raceway with screws (if not routing cable inside wall)
• Plastic cable (zip) ties
• Cable tacks/staples
2. Recommended tools
• Drill (or hammer drill for concrete walls)
• Drill bits (or masonry bits for concrete walls)
• Slotted screwdriver
• Level or ruler/tape measure
• Crimp pliers or scissors
• Tin snips (optional)
• Ladder
• Staple gun
• Safety goggles
General safety precautions
• Do not install or use the CB2000 near water or heat sources
• Clean only with a dry cloth
• Protect all cables from wear and damage from doors and other hazards
• Use only accessories specified by FrontRow
• Refer servicing to qualified service personnel
• Wear safety goggles when using power tools
Step 5:
Physical Installation Prep
To Next Page
Loading...
Need help?
General