Frymaster 1814 Series Gas Fryers
Chapter 5: Filtration Operation
5-7
5.4.2 Filtering Tools
Assemble tools to be used for filtering. These are supplied with the filter starter kit included with
the fryer/filter system:
• Frypot/Filter Brush - used to clean frypot and filter pan sides and bottom, heating elements,
and to dislodge sediment during filtration or oil change.
• Clean-out Rod (design may vary) - used to dislodge heavy debris in the drain tube (when needed).
• Filter Powder.
• Filter Paper.
The following tools are not required, but are recommended to make the filtering task easier.
• Measuring Cup - used to measure filter powder.
• Stainless Steel Crumb Scoop - for removing large debris from oil prior to filtering.
Note: Always wear oil-resistant, insulated gloves and/or protective gear when
working with hot oil.
To Next Page
Loading...
