What does it mean when my Frymaster Gen III LOV M4000 displays 'TEMPERATURE PROBE FAILURE'?
This indicates a problem with the temperature measuring circuitry, including the probe, a damaged controller wiring harness, or connector. Shut the fryer down.
What to do if the filter pump won't start or stops while filtering in my Frymaster Gen III LOV Fryer?
If the filter pump won't start or stops during filtering, verify that the power cord is fully plugged in and the circuit breaker is not tripped. If the motor is too hot to touch for more than a few seconds, allow the motor to cool for at least 45 minutes, then press the Pump Reset Switch.
What to do if my Frymaster Gen III LOV M4000 displays 'CHANGE FILTER PAD'?
If the M4000 displays 'CHANGE FILTER PAD', change the filter pad/paper. Make sure the filter pan has been removed from the fryer for at least 30 seconds. It's important not to ignore these prompts.
Why won't auto filtration start on my Frymaster Gen III LOV?
If auto filtration won’t start, make sure the oil level is at the top oil fill line, the oil temperature is at the setpoint, and the filter pan is fully seated. Also, verify that filtration in the recipe settings is set to ON.
Why is the heating indicator on, but my Frymaster Fryer isn't heating?
If the heating indicator is on but the fryer isn't heating, check that the main power cord and 120V are fully seated and locked in place, and that the circuit breaker hasn't tripped.
What does it mean when my Frymaster Gen III LOV Fryer M4000 displays 'HOT-HI- 1'?
This indicates that the frypot temperature is more than 410ºF (210ºC) or, in CE countries, 395ºF (202ºC). Shut the fryer down immediately.
Why does my Frymaster Gen III LOV heat until the high-limit trips without the heat indicator ON?
The contactor or controller has failed.
What to do if my Frymaster Gen III LOV Fryer M4000 displays 'SERVICE REQUIRED' followed by an error message?
If the M4000 displays 'SERVICE REQUIRED' followed by an error message, press ? (2 NO) to continue cooking. In some cases, cooking may not be available.
What does it mean when my Frymaster Gen III LOV Fryer M4000 displays 'VAT ID CONNECTOR NOT CONNECTED'?
This message indicates that the controller locator is missing or disconnected. Ensure the 6-pin locator is connected to the rear of the controller and properly grounded in the control box.
What to do if my Frymaster Gen III LOV controller locks up?
If the controller locks up, remove and restore power to the controller.
Essential safety guidelines and warnings for fryer operation.
Basic rules for safe and efficient installation.
Details on proper grounding for electrical safety.
Technical specifications for electrical power supply.
Steps for preparing and turning off the fryer.
Details the controller's buttons and their uses.
Step-by-step guide for daily fryer operation.
Describes the automatic oil filtering process.
Addresses issues with the controller and heating.
Explains various error codes and their meanings.
To Next Page
General