What to do if my Frymaster Fryer M4000 displays 'NO MENU GROUP AVAILABLE FOR SELECTION'?
If the M4000 displays 'NO MENU GROUP AVAILABLE FOR SELECTION', create a new MENU group and add recipes to the group.
Why is my Frymaster Gen III LOV Fryer not heating up?
If your Frymaster Fryer isn't heating, check that the main power cord and the 120V are fully connected and locked into their receptacle and that the circuit breaker hasn't tripped. If it still fails to heat, the controller or other components may have failed.
Why does my Frymaster Gen III LOV filter after every cook cycle?
This issue arises when the 'filter after' setting is incorrect. To resolve this, change or overwrite the filter after setting by re-entering the filter after value in Manager Settings, Filter Attributes.
What to do if my Frymaster Gen III LOV controller locks up?
If the controller locks up, remove and restore power to the controller.
How to change the temperature scale on my Frymaster Gen III LOV Fryer M4000 display?
To toggle between Fahrenheit and Celsius, enter Manager settings, go to temperature, and toggle the temperature scale. Turn the controller on to check the temperature. Repeat if the desired scale isn't displayed.
Why is the oil return very slow when the filter pump is running on my Frymaster Gen III LOV Fryer?
Slow oil return could be due to improperly installed or prepared filter pan components. Remove the oil from the filter pan and replace the filter pad/paper, ensuring that the filter screen is in place under the pad/paper. Verify, if using a pad, that the rough side is facing up and that O-rings are present and in good condition on the filter pan connection fitting. Also, the pre-filter screen may be clogged and need cleaning.
What does it mean when my Frymaster Gen III LOV Fryer M4000 displays 'IS VAT FULL? YES NO' after filtration?
This message indicates a filter error. This can occur due to a dirty or clogged filter pad or paper, a clogged pre-filter, improperly installed filter pan components, worn or missing O-rings, cold oil, or a tripped filter motor thermal.
Why won't the MAINTENANCE FILTER start on my Frymaster Gen III LOV Fryer?
The MAINTENANCE FILTER won’t start if the temperature is too low. Ensure the fryer is at setpoint before starting MAINTENANCE FILTER.
Why is the heating indicator on, but my Frymaster Fryer isn't heating?
If the heating indicator is on but the fryer isn't heating, check that the main power cord and 120V are fully seated and locked in place, and that the circuit breaker hasn't tripped.
Why won't auto filtration start on my Frymaster Gen III LOV?
If auto filtration won’t start, make sure the oil level is at the top oil fill line, the oil temperature is at the setpoint, and the filter pan is fully seated. Also, verify that filtration in the recipe settings is set to ON.
Essential safety guidelines and warnings for fryer operation.
Basic rules for safe and efficient installation.
Details on proper grounding for electrical safety.
Technical specifications for electrical power supply.
Steps for preparing and turning off the fryer.
Details the controller's buttons and their uses.
Step-by-step guide for daily fryer operation.
Describes the automatic oil filtering process.
Addresses issues with the controller and heating.
Explains various error codes and their meanings.
To Next Page
General