5-4
OIL LEVEL TOO LOW
5. Displayed if the oil level is too low. Press the √ (check) button to
acknowledge issue and return to idle cook mode. Check to see
if the JIB is low on oil. If JIB is not low and this continues to
occur, contact your FAS.
SKIM DEBRIS FROM VAT -
PRESS CONFIRM WHEN COMPLETE
6. Skim the crumbs from the oil with a front to back motion,
removing as many crumbs as possible from each vat. This is
critical to optimizing usable oil life and quality of the oil. Press
the √ (check) button when complete.
INSERT PAN
7. Push the filter pan fully into place. Displayed if the filter pan is
not fully engaged.
DRAINING IN PROGRESS 8. No action required as oil drains into filter pan.
WASHING IN PROGRESS 9. No action required as debris is flushed from the vat.
FILLING IN PROGRESS 10. No action required as the vat refills.
PREHEAT 11. No action required as the fryer heats to setpoint.
START 12. Fryer is ready for use. Displayed once fryer reaches setpoint.
The complete filtering process takes roughly four minutes.
NOTE: If during filtration the filter pan is removed, the filtration process stops and resumes once pan is reseated
into place.
DANGER
Keep all items out of drains. Closing actuators may cause damage or injury.
Should the auto filtration procedure fail an error message is generated. Follow the instructions on the controller to
clear the error.
When FILTER BUSY is displayed the FIB board is waiting on another vat to be filtered or waiting on another issue to
clear. Press the √ (check) button and wait 15 minutes to see if problem is corrected. If not, call your local FAS.
DANGER
Do not drain more than one frypot at a time into the built-in filtration unit to avoid overflow and spillage of
hot oil that may cause severe burns, slipping and falling.
WARNING
The filter motor is equipped with a manual reset switch in case the filter motor overheats or an electrical
fault occurs. If this switch trips, turn off power to the filter system and allow the pump motor to cool 20
minutes before attempting to reset the switch (see photo on the following page).
WARNING
Use caution and wear appropriate safety equipment when resetting the filter motor reset switch. Resetting
the switch must be accomplished with care to avoid the possibility of a serious burn from careless
maneuvering around the drain tube and frypot.
Filter Motor Reset Switch
To Next Page
Loading...
