Connecting the Power
Connecting to the RJ45 Ports
1. Connect an Ethernet cable to the RJ45 port of the KVM switch.
2. Connect the other end of the Ethernet cable to the RJ45 port of the supplied RJ45 to VGA
Interface Module and then connect the VGA port of the Module to a server or computer.
1. Plug the provided AC power cord into the power port on the back of the KVM switch.
2. Connect the other end of the power cord to an AC power source.
3. Open the power switch on the rear panel.
WARNING: Do not install power cables while the power switch is on.
NOTE: DC power cord is not included in the package.
V
LAN
DC
Vac
Hz
RS
V
LAN
DC
Vac
Hz
RS
To Next Page
Loading...
