When mounting the main circuit terminal block cover, fit it according to the guide on the inverter.
Figure 3.3 Mounting the main circuit terminal block cover
(For Inverters with a Capacity of 5.5 and 7.5 kW)
(3) For inverters with a capacity of 11 and 15 kW
To remove the terminal cover, first loosen the terminal cover fixing screw, put your finger in the dimple of the terminal cover (labeled
"PULL"), and then pull it up towards you.
To remove the main circuit terminal block cover, hold the handles on the both sides of the main circuit terminal block cover, and pull it
up.
Figure 3.4 Removing the Covers (For Inverters with a Capacity of 11 and 15 kW)
When mounting the main circuit terminal block cover, fit it according to the guide on the inverter.
Insert the main circuit terminal block cover by fitting the part labeled "GUIDE" according to the guide on the inverter.
Push where "PUSH" are labeled to snap it into the inverter.
Figure 3.5 Mounting the Main Circuit Terminal Block Cover
(For Inverters with a Capacity of 11 and 15 kW)
To Next Page
Loading...
