Fax/Internet Fax
239
Fax
4
2 Select [Shift], and enter in the following format: "<", "port number", ">", "recipient’s
telephone number".
The following shows the corresponding lines to each port:
<1>: Line 1
<2>: Line 2
<3>: Line 3
Example when using Line 1:
<1>XXXXXXXXXX
Specifying a line (port) using [Line Selection]
You can specify a line using [Line Selection].
1 Select [Line Selection].
z
To display [Line Selection], the System Administrator setting is required. For more information, refer to "Tools"
> "Fax Service Settings" > "Screen Defaults" > "Fax Screen Default" in the Administrator Guide.
z
When [Line Selection] is displayed, [Lighten / Darken] cannot be displayed. In this case, you can set the fax
density on the [Layout Adjustment] tab. For more information, refer to "Lighten / Darken (Adjusting Fax
Density)" (P.253).
To Next Page
Loading...
